If you have more than one Meet X device, you may need to use different remote controls to control different Meet X devices. The guide is about how to set up the remote control to match different Meet X devices.
Q1 How to match the remote control with the Meet X?
Step 1 Shut down the Meet X and unplug the power cable to make it completely off.
Step 2 Press the [SET] and [*] buttons of the remote control at the same time for 3-5 seconds until the LED light on the remote control starts flashing.
Step 3 Plug the power cable back into the Meet X device and the LED light on the remote control stops flashing, which means they are matched sucessfully.
Step 4 Press the power button on the remote control or at the back of the Meet X to turn it on. Then you can use the remote control to check if it can control the Meet X.
Note: After the setup, the Meet X can only be controlled by this remote control, but this remote control can also control other Meet X devices which are not matched with any other remote control yet. Therefore, you need to set up another remote control to match another Meet X.
Q2 How to clear the match-up?
If you need to clear up the match-up, you can use a new remote control to match the device, or follow the steps below to clear it up:
Step 1 Shut down the Meet X, but do not unplug the power cable. Make sure it is still power supplied.
Step 2 Press the [SET] and [#] buttons of the remote control at the same time for 3-5 seconds until the LED light on the remote control starts flashing.
Step 3 Unplug the power cable from the Meet X and then plug the power cable back in. Then the LED light on the remote control stops flashing, which means the match up is cleared.